Nortel Networks P0990474 Manual do Utilizador descarregar pdf (Página 21)

CallPilot Mini/CallPilot 150 Installation and Maintenance Guide

Chapter 3

Preparing to install the CallPilot Mini/CallPilot 150

This chapter explains what you need before you install the CallPilot Mini/CallPilot 150.

Environment

Make sure the installation area is:

• clean, free of dust, dry and well ventilated

• between 0 and 50 degrees Celsius

• non-condensing relative humidity between 5 percent and 95 percent

• at least 4 m, or 13 ft., from any equipment that could produce electromagnetic, radio frequency

and electrostatic interference

• a wall area about 1 m (3 ft.) square

• closer than 15 m, or 50 ft., of cable length from the Norstar KSU or Meridian 1 PBX

• within 1.5 m, or about 5 ft., of a three-wire grounded electrical outlet

• a minimum of 16 cm, or 6 in., from a corner wall or other component

• a minimum of 46 cm, about 18 in., from the floor, to prevent water damage

Electrical service

Make sure the power is:

• 115/230 VAC nominal; range 100 to 240 V

• 50/60 Hz nominal; range 47 to 63 Hz

• Third-wire ground

• Unswitched

Opening the kit

Open the box and ensure that you have all the pieces, as described below:

• CallPilot Mini/CallPilot 150

• Power supply and power cord

• Wall Mount Bracket

• Four-wire, two-meter line cord

• Documentation and Client Software CD

• CallPilot Mini EMC Kit (CallPilot Mini only)

• Shielded Ethernet cable (CallPilot Mini only)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 93 94

Sem comentários

Nortel Networks P0990474 Manual do Utilizador Página 21