Nortel Networks Network Router BCM 4.0 Manual do Utilizador descarregar pdf (Página 18)

18 Chapter 3 Physical installation

N0060602N0060602

To attach the rack-mount brackets

1 Place the BCM unit on a flat, clean surface.

2 Align the screw holes between the BCM unit and one of the rack-mount brackets.

3 Fasten the bracket to the BCM unit using four screws. Refer to Figure 4.

4 Repeat steps 2 and 3 for the other rack-mount bracket.

5 If the BCM system has an expansion unit, attach the rack-mount brackets to the expansion unit

in the same way as the main unit.

Figure 4 Attach the rack-mount bracket to the BCM400 main unit

To mount a BCM unit in an equipment rack

1 Determine the location in the rack where you want to install the BCM unit.

2 Position the BCM unit in the rack. Have an assistant hold the BCM unit.

3 Align the holes in the rack-mount bracket with the holes in the equipment rack rails.

4 Fasten the rack-mount brackets to the rack using four screws (see Figure 5).

Caution: Use only the screws supplied with the rack-mount bracket. Other screws

can damage the unit.

6 minutes/unit

The rack-mount brackets for

the BCM200 main unit and

expansion unit are installed in

a similar manner.

6 minutes/unit

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Sem comentários

Nortel Networks Network Router BCM 4.0 Manual do Utilizador Página 18