Nortel Networks 8672ATME Manual do Utilizador descarregar pdf (Página 143)

Chapter 6 Configuring the Passport 8672ATME Module 143

Using the Passport 8672ATME Module

Configuring an IPX routing 1483 PVC using the CLI

To configure the Passport 8672ATME Module for this setup using the CLI:

1 To create two VLANs by port, enter:

config vlan 2 create byport 1

config vlan 3 create byport 1

2 To add an ATM port (in this example, 1/1) and several Ethernet ports (in this

example, 3/40 to 3/48) to the VLAN, enter:

config vlan 2 port add 1/1

config vlan 3 port add 3/40-3/48

3 To configure IPX network numbers on both VLANs (use two different

subnets), enter:

config vlan 2 ipx <

ipx network number

config vlan 3 ipx <

ipx network number

4 To enable forwarding on IPX, enter:

config ipx forwarding enable <

ipx network number

5 If necessary, use the following CLI commands to change RIP parameters:

config ipx rip <

sub-command

config ipx forwarding <

sub-command

6 To configure a 1483 PVC with LLC/SNAP-encapsulation and UBR, enter:

config atm 1/1 pvc create 0.100 enc 1483-llc serv

ubr

7 To associate a 1483 IPX routed PVC with a VLAN, enter:

config atm 1/1 pvc 1483 ipx create 2 0.100 <

IPX

network number of existing vlan

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 161 162

Sem comentários

Nortel Networks 8672ATME Manual do Utilizador Página 143