Nortel Networks BCM50 Manual do Utilizador descarregar pdf (Página 258)

258 Chapter 10 BCM50 Utilities

NN40020-600NN40020-600

Enabling UIP message monitoring

1 Click the UIP tab.

2 To enable or disable monitoring of MCDN over IP messages for calls made over IP trunks,

select or clear the MCDN over IP check box.

3 To select an expansion module, select one of the following from the Bus selection field:

•Bus 3

•Bus 4

•Bus 5

•Bus 6

•Bus 7

•Bus 8

4 Select the type of ISDN module or modules:

• PRI — enables monitoring of a DTI module

• BRI — enables monitoring of BRI loops

For example, you can monitor UIP messages for loops 1 and 2 of a BRI module connected to Bus

5 and a PRI module connected to Bus 6. To do this, you would:

• Select Bus 5 - BRI, then select Module 1 - Loop 1

• SelectBus 5 - BRI, then select Module 1 - Loop 2

• Select Bus 6 - PRI

To disable monitoring of UIP messages

1 Click the UIP tab.

2 From the Bus drop-down list, select the bus you want to disable.

3 Select the Off radio button..

Caution: Monitoring UIP messages may affect the performance of the BCM50

system or connected peripherals. For example, if IP sets or voice ports make or

receive a high number of calls over PRI trunks, monitoring UIP increases the

amount of signalling data and may increase the response time for IP sets or voice

ports. Therefore, it is strongly recommended that you monitor only a single UIP

module at a time and restrict the monitoring time.

Note: To disable monitoring of UIP messages for MCDN over IP, you must

deselet the MCDN over IP check box.

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 351 352

Sem comentários

Nortel Networks BCM50 Manual do Utilizador Página 258