Nortel Networks Nortel Backbone Link Node Router 5030 Manual do Utilizador

TM 1HotWire 5030 POTS Splitter Customer PremisesInstallation InstructionsDocument Number 5030-A2-GN10-10October 1997Before You BeginVerify that:The l

105030 POTS Splitter Technical SpecificationsItem Specification*Height x Width x Depth 6.65″ x 5.44″ x 2.25″ (16.89 cm x 13.82 cm x 5.72 cm)Weight 10

11Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product orincluded in the manual.2. This product

12If the Model 5030 Telephone Line Filter causes harm to the telephone network, thetelephone company will notify you in advance that temporary discon

2What Does the POTS Splitter Do?The POTS splitter and HotWire Remote Termination Unit (RTU) are components in theRADSL Access System. This system pro

97-15247POTS Splitter Housing 3Mounting the POTS Splitter HousingThe POTS splitter can be placed:H On the outside of the structure near the NID or pun

97-15437-01LeverClosureScrew 4Preparing the POTS Splitter" Procedure1. Unscrew the closure screw and open the housing by pressing on the lever on

5Installing the POTS Splitter WiringThe local loop ends at the punchdown block or NID. Wiring must be connected from thecustomer premises (CP) side o

6DSL/POTSFrom LocalLoopTelephone Network Interface Device (NID)GroundTipT1(Green)RingR1(Red)97-15502Existing POTSWiring toTelephoneDemarcation PointC

7Reconnecting to the Local Loop" Procedure1. Feed new jumper wiring through the POTS splitter rubber grommet. Remove theinsulation at the end of

97-15251LeverClosureScrew 83. Locate the T1/R1 connectors on the customer premises side of the punchdownblock or NID where the existing POTS wiring wa

9DSL Access Wiring" Procedure1. Attach new wiring to the T1/R1 connectors that will go to the DSL jack from thepunchdown block or NID.2. Tighten