Nortel Networks 10BASE-T Manual do Utilizador descarregar pdf (Página 128)

Using the BayStack 410-24T 10BASE-T Switch

2-10

309985-C Rev 00

Console/Comm Port

The serial console interface is an RS-232 port that enables a connection to a PC or

terminal for monitoring and configuring a standalone switch or a stack

configuration.You can also connect this port to an external modem to enable remote

dial-in management of the switch. The port is a male DB-9 connector, implemented

as a data communication equipment (DCE) connection.

To use the Console/Comm port, you need the following equipment:

• A VT100 or ANSI-compatible terminal, or a PC with a serial port and the

ability to emulate a VT100 terminal.

Configure the terminal settings as follows:

-- 9600 baud

-- No parity

-- 8 bits

-- 1 stop bit

-- Flow control set to Xon/Xoff

-- Window Terminal Emulator option set to NO

-- Terminal Preferences: Function, Arrow, and Control keys active

-- Buffer size set to 24

• A UL-listed straight-through RS-232 cable with a female DB-9 connector for

the console port on the switch.

The other end of the cable must have a connector appropriate to the serial port

on your computer or terminal. (Most terminals or computers use a male DB-25

connector.)

Any cable connected to the console port must be shielded to comply with

emissions regulations and requirements.

See “DB-9 (RS-232-D) Console/Comm Port Connector

” on page D-1 for a

description of the pin assignments.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 329 330

Sem comentários

Nortel Networks 10BASE-T Manual do Utilizador Página 128